Cleaning And Replacement Of The Electric Brush - Fakir Starky HSA 144 Bedienungsanleitung

Cleaning.and replacement of the
electric suction brush
Cleaning and care
6) After taken out the motor protection filter, wash
the foam by water and install it back to the appli-
ance after is it completely dried.
If the brush is worn or stuck, it should be cleaned or
replaced (only with components with the same spec-
ification) to make sure the brush can smoothly oper-
ate and ensure the safety; the rotation shaft of the
electrical soft roller brush tends to be stuck by cotton
fibers, hairs and the like, so the rotation shaft should
be kept cleaned.
1) Press the brush release button to take out
the brush (left bottom figure), and use a
flathead screwdriver to left rotate the small
cover at the left bottom of the brush (right
bottom figure); then, use the screwdriver to
remove the dust and hairs or use your fin-
gers to pull the edge of the soft brush to
remove the dust and hairs.
2) If there are matted cotton fibers or hairs,
use a scissor to cut them and clean the ro-
tation shaft to make sure the rotation shaft
can rotate smoothly; after the rotation shaft
is cleaned, please install the rotation shaft
back to the appliance by reverse process.
13