Gorenje tiki TGU 50 N Gebrauchsanweisung Seite 7

Dear buyer, we thank you for purchase of our product.
Prior to installation and first use of the electric water heater, please carefully read
these instructions.
THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN)
WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES, OR LACK OF
EXPERIENCE AND KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN SUPERVISION OR
INSTRUCTION CONCERNING USE OF THE APPLIANCE BY PERSON RESPONSIBLE
FOR THEIR SAFETY.
CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY WITH
THE APPLIANCE.
This water heater has been manufactured in compliance with the relevant standards and tested by
the relevant authorities as indicated by the Safety Certificate and the Electromagnetic Compatibility
Certificate. The technical characteristics of the product are listed on the label affixed between the inlet
and outlet pipes. The installation must be carried out by qualified staff. All repairs and maintenance
work within the water heater, e.g. lime removal or inspection/replacement of the protective anticorrosion
anode, must be carried out by the authorised maintenance service provider.
BUILDING-IN
The water heater shall be built-in as close as possible to the outlets. When installing the water heater
in a room with bat htub or shower tub, take into account requirements defined in IEC Standard 60364-
7-701 (VDE 0100, Part 701). It has to be fitted to the wall using appropriate rag bolts with minimum
diameter of 8 mm. The wall with feeble charging ability must be on the spot where the water heater shall
be hanged suitably reinforced. Due the universal construction the waterheater it can be fixed vertically
on the wall or horizontally on the wall (output pipes must be on the left). We recommend the distance
between the water heater and the ceiling is large enough to allow simple replacement of the MG anode
(see dimension G in the Installation Drawing), in order to avoid unnecessary dismounting of the heater
during the servicing intervention.
TECHNICAL PROPERTIES OF THE APPLIANCE
Type
Model
Volume
Rated pressure
Weight / Filled with water
Anti-corrosion protection of tank
Connected power
Voltage
Heating time to 75°C
1)
Quantity of mixed water at 40°C [ l ]
Energy consumption
2)
1) Time for heating of the whole volume of heater with electric immersion heater by entering temperature of
cold water from water supply 10°C.
2) Energy consumption to maintain stable temperature of water in the water heater 65°C at surrounding
temperature 20°C, measured according to SIST EN 60379.
TG 50 N
TGU 50 N
[ l ] 50
[MPa ]
[kg] 24/74
[ W ]
[V~]
55
[ h ] 1
95
[kWh/24h] 1,32/1,45
TG 80 N TG 100 N
TGU 80 N TGU 100 N TGU 120 N TGU 150 N TGU 200 N
80 100
0,6
30/110 34/134
Enameled/Mg Anode
2000
230
05 55
3 3
146 193
1,85/2, 1 0 2,20/2,45 2,60/2,90 3,20/3,60 2,80/3, 1 0
TG 120 N TG 150 N
120 150
38/158 44/194
35 45
4 5
226 282
TG 200 N
200
65/265
40
7
360
7