How To Start - Use - Stop The Engine - Stiga A 305 Gebrauchsanweisung

12
EN

6. HOW TO START - USE - STOP THE ENGINE

STARTING THE ENGINE
WARNING!
start ed in an area at least 3 metres from where
you refi lled the fuel tank.
Before starting the engine:
– Place the machine fi rmly on the ground.
– Take off the bar cover.
– Make sure the bar is not touching the ground or
any other object.
• Cold starting
NOTE
means starting it after at least 5 minutes from when
it was switched off or after refuelling.
To start the engine (Fig. 8):
1. Check that the chain brake is engaged (with the
front hand guard pushed forward).
2. Set the switch (1) to «START».
3. Pull the knob (2) as far as possible to engage
the starter.
4. Press the primer device button (3) 3 or 4 times
to prime the carburettor.
5. Hold the machine fi rmly on the ground with one
hand on the grip, in order not to lose control of
the machine during start-up (Ill. 9).
WARNING!
fi rmly, the force of the engine could cause the
user to lose his balance or direct the bar to­
wards him or an obstacle.
6. Pull the starter rope slowly for 10 - 15 cm until
you feel some resistance, then tug it hard a few
times until you hear the engine turn over.
WARNING!
ble around your hand.
DANGER!
by holding on to the starter cable and allowing
it to fall. This is an extremely dangerous
method as you lose complete control over the
machine and the chain.
The engine must be
A "cold" start of the engine
If the machine is not held
Never wind the starter ca-
Never start the chain saw
HOW TO START - USE - STOP THE ENGINE
IMPORTANT
rope, do not pull the whole length of it or let it slide
along the edge of the cable guide hole. Release
the starter gradually, to avoid letting it fl y back un-
controllably.
7. Push the choke knob inward halfway.
8. Pull the starter rope again until the engine starts
as normal
NOTE
repeatedly with the choke on, it may fl ood the en-
gine and make starting diffi cult. If you have fl ooded
the engine, remove the spark plug and gently pull
the handle on the starter rope to eliminate any
excess fuel; then dry the spark plug electrodes and
replace it on the engine.
9. When the engine has started, press the throttle
trigger to disconnect the starter and allow the
engine to idle.
IMPORTANT
high power with the chain brake engaged, as this
could cause overheating and damage to the
clutch.
10. Let the engine run idle for at least 1 minute
before using the machine.
• Hot starting
When hot starting (immediately after stopping the
engine), follow the procedure indicated above in
points 1 - 2 - 5 - 6 - 9.
WARNING!
struc tions under "For your safety" (
USE OF THE ENGINE (Fig. 10)
IMPORTANT
brake, pulling the lever towards you before using
the accelerator.
The chain speed is regulated by the throttle trigger
(1) on the rear handgrip (2).
The throttle trigger only works if the lockout (3) is
pressed at the same time.
The movement is transmitted from the engine to
the chain by a centrifugal mass clutch that pre-
vents the chain from moving when the engine is
running at minimum speed.
To avoid breaking the starter
If the starter rope is pulled
Do not let the engine run at
Carefully follow the in-
Always disengage the chain
3.1).