Gorenje tiki TG 30 N Gebrauchsanweisung Seite 7

Dear buyer, we thank you for purchase of our product.
PRIOR TO INSTALLATION AND FIRST USE OF THE ELECTRIC WATER HEATER,
PLEASE CAREFULLY READ THESE INSTRUCTIONS.
THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN)
WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES, OR LACK OF
EXPERIENCE AND KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN SUPERVISION
OR INSTRUCTION CONCERNING USE OF THE APPLIANCE BY PERSON RESPONSIBLE
FOR THEIR SAFETY.
CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY WITH
THE APPLIANCE.
This water heater has been manufactured in compliance with the relevant standards
and tested by the relevant authorities as indicated by the Safety Certifi cate and the
Electromagnetic Compatibility Certifi cate. The technical characteristics of the product are
listed on the label affi xed between the inlet and outlet pipes. The installation must be carried
out by qualifi ed staff. All repairs and maintenance work within the water heater, e.g. lime
removal or inspection/replacement of the protective anticorrosion anode, must be carried out
by the authorised maintenance service provider.
BUILDING-IN
The water heater shall be built-in as close as possible to the outlets. When installing the
water heater in a room with bathtub or shower, take into account requirements defi ned in IEC
Standard 60364-7-701 (VDE 0100, Part 701). It has to be fi tted to the wall using appropriate
rag bolts with minimum diameter of 8 mm. The wall with feeble charging ability must be
on the spot where the water heater shall be hanged suitably reinforced. The water heater
may be fi xed upon the wall only vertically. We recommend the distance between the water
heater and the ceiling is large enough to allow simple replacement of the MG anode (see
dimension G in the Installation Drawing), in order to avoid unnecessary dismounting of the
heater during the servicing intervention.
TECHNICAL PROPERTIES OF THE APPLIANCE
Type
Model
Volume
Rated pressure
Weight / Filled with water
Anti-corrosion protection of tank
Connected power
Voltage
Heating time to 75°C
1)
Quantity of mixed water at 40°C [ l ]
Energy consumption
2)
1) Time for heating of the whole volume of heater with electric immersion heater by entering temperature of
cold water from water supply 15°C.
2) Energy consumption to maintain stable temperature of water in the water heater 65°C at surrounding
temperature 20°C, measured according to EN 60379.
159419_tiki.indd 7 159419_tiki.indd 7
TG 30 N TG 50 N
TG 30 N TG 50 N
[ l ] 30 50
[ MPa]
[ kg ] 20/50 24/74
[ W ]
[ V~ ]
[ h ] 1 1
05
50 89
[kWh/24h ] 0,90 1,32
TG 80 N TG 100 N
TG 80 N TG 100 N
80 100
0,6
30/110 34/134
Enameled / Mg Anode
2000
230
3 3
55 05 55
145 200
1,85 2,20
TG 120 N TG 150 N TG 200 N
TG 120 N TG 150 N TG 200 N
120 150 200
38/158 44/194 70/270
4 5 7
35 45
236 298 399
2,60 3,20 2,80
15.3.2010 8:15:00 15.3.2010 8:15:00
40
7