Suzuki AN400 2002 Serviceanleitung Seite 311

SIDE-STAND SWITCH INSPECTION
• Remove the side leg shield. (!7-15)
• Disconnect the side-stand switch coupler 1.
• Measure the voltage between green and Black/White lead
wire.
If the resistance is out of specification, replace the switch.
# 09900-25008: Multi-circuit tester set
) Tester knob indication: Diode test (*)
ON
(Side-stand up)
OFF
(Side-stand down)
NOTE:
If the tester reads under 1.4 V when the tester probes are not
connected, replace its battery.
SAFETY RELAY INSPECTION
• Remove the front box. (!7-14)
• Remove the safety relay 1.
• Check that no continuity exists between the terminals A and
B. If continuity is found, replace the relay.
# 09900-25008: Multi-circuit tester set
+ Tester knob indication: Continuity test (,)
• Check there is continuity between the terminals A and B
when 12V battery voltage is applied; positive to the terminal
C and negative to the terminal D. If no continuity is noted,
the relay must be replaced.
Green Black/White
( + probe) ( - probe)
0.4 – 0.6 V
1.4 V and more
(Tester's battery voltage)
http://www.motorcycle.in.th
ELECTRICAL SYSTEM 8-19