Camshaft - Suzuki AN400 2002 Serviceanleitung

• Install the cylinder head 3.
• Install the copper washers 4 and bolts 5.
• Tighten the cylinder head bolts and nuts diagonally and
evenly.
• The head bolt tightening must be performed in two stages, ini-
tial and final tightening.
# Cylinder head bolt
Initial tightening:25 N·m (2.5 kgf-m, 18.0 lb-ft)
Final tightening: 41 N·m (4.1 kgf-m, 29.5 lb-ft)
# Cylinder head nut (M8): 25 N·m (2.5 kgf-m, 18.0 lb-ft)
Cylinder head nut (M6): 10 N·m (1.0 kgf-m, 7.0 lb-ft)
Cylinder nut

CAMSHAFT

• With the cam chain held by hand, turn the crankshaft in nor-
mal direction and align "T" mark on the generator rotor with
the triangle mark A on the generator cover.
• Install the C-ring.
• Position the camshaft 1, cam chain 2 and cam sprocket 3.
$
Position the cam sprocket so that the stamped mark
side faces outside.
: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
http://www.motorcycle.in.th
ENGINE 3-79