Connecting To The Gate And/Or Pedestrian Gate - SOMFY V 500 Connect Bedienungsanleitung

CONNECTING TO THE GATE AND/OR PEDESTRIAN GATE

In order to remote control your gate/pedestrian gate, please make sure that the video door phone call station is correctly wired to
the gate motor, or the pedestrian gate's electric latch. Otherwise, it will not be controllable via the "Somfy Protect" app.
CONNECTING TO A SOMFY GATE MOTORISATION
In compliance with standard EN 12453 on the safe use of motorised doors and gates, using a video door phone to
control an automatic gate or garage door that may not be visible to the user necessarily requires the installation
of a photoelectric cell-type security device on this automated system.
Failure to comply with these instructions absolves Somfy of any liability resulting from damage that may be
caused.
[1].
Switch the power supply to your Somfy gate motor off.
[2].
Remove the cover from the control cabinet or from the motor containing the electronics.
[3].
Connect the door station dry contact output (COM and NO) to the drive electronics. If connecting the door station is not
explained in the drive manual, follow the instructions for connecting a key switch.
Door station
M- M+ L- L+ NO COM NC
Connect...
COM
NO
When the drive is solar-powered, the wired controls are deactivated. It can only be controlled by RTS radio control via the
indoor monitor.
To connect the door station to another gate drive model, please refer to the relevant installation guide.
CONNECTING TO AN ELECTRIC LATCH (PEDESTRIAN GATE)
Connect terminal blocks L- and L+ of the door station to the electric
latch.
Observe the correct polarity: refer to the electric latch instructions.
The latch activation time (2, 5 or 10 seconds) is set via the "Settings"
menu on the indoor monitor.
When installation is complete, first switch your gate drive on then
your connected video door phone.
The screen and the operating LED located on the edge of the indoor
monitor are activated. You can now set the parameters.
Important: The mains adaptor must be installed no more than 8 m
from the indoor monitor and must be easily accessible.
28
to the START terminal
blocks
5
6
POWERING ON THE INSTALLATION
Somfy drive electronics
to the BUS terminal
blocks
3
4
to the numbered terminal blocks
3
5 for complete opening
6 for pedestrian opening
12V 800 mA max
LED