AERMEC FCW 212V Bedienungsanleitung Seite 33

IMpORTANT
Note for fCw series with microprocessor controller:
- The two control types, wired control panel (pfw2) and remote control (TLw2), cannot be used at the same time on the
same fan coil unit.
– If the fan coil is off, all the previous settings made are kept in the memory except for the TIMER setting and SLEEp mode.
– If the fan coil is turned on using the (ON/Off) key, the TIMER setting and SLEEp mode are cancelled.
DIRECTION Of THE AIR fLOw
The blades on the air discharge are arranged to direct the air
in two directions:
– vertical blades, to be adjusted manually
– motorised horizontal blades for versions with micropro-
cessor controller, to be adjusted only by means of the
TLW2 remote control or the PFW2 wired control panel
– horizontal blades for versions without microprocessor con-
troller to be adjusted manually.
ADJUSTING THE vERTICAL BLADES
– turn the vertical blades as indicated in the diagram
– both in heating or cooling mode it is advisable for the air
flow not to hit people directly.
MOTORISED HORIZONTAL BLADES
Never adjust the motorised horizontal blades manually.
Any manual operation on the blades may damage the sys-
tem and cause a malfunction.
When the unit is off the blades close and cover the air flow
outlet.
IMpORTANT
Under particular external conditions condensate might occur
on the surface of the blades (during cooling and dehumidifica-
tion) and drip onto the surfaces below.
The direction of air flow as shown in
TLw2
pfw2
IFCW3LJ 1210 - 5375700_01
the diagram
TLW2 PFW2
LOUVER
33