BRAND Transferpettor micro Gebrauchsanleitung Seite 77

Put on new seal
b.
4.7.3 Change piston rod
Do not touch the contaminated area of the cap and seal. Wear
protective gloves.
997478
f. Allow the pipetting button to slide
back.
a. Put on new seal
b. Place the new seal in the conical re-
cess of the red attachment block. For
the 0.5 ml and 1 ml sizes, the blue at-
tachment block must be used.
c. Press the piston rod into the seal as
far as it will go.
d. Check that the seal is firmly seated.
e. Push on cap
CAUTION
Operating manual
77