Speed Levels; Controllable Functions; Service And Maintenance - LGB 212 Serie Bedienungsanleitung

Programming by means of Pages (Universal-Handy 55015)
All CVs up to CV 1024 can be changed with programming by means of pages. The
process can be compared to programming by means of CVs, but it uses the CVs 1 to 4
in place of CV 5 for the value. Pages are areas in which 4 addresses can be summa-
rized. CVs 1 to 4 correspond then to the 4 addresses that are summarized on the page.
The numbers to be entered can be generated with the following equations:
(CV - 1 ) / 4 = Page Whole number result is Page
(decimal x 4) + 1 = Data CV
If for example CV 322 is to be programmed at 200, the following calculation will result:
(322 -1) / 4 = 80,25 Page 80; CV6 = 80
0,25 x 4 + 1 = 2
In order to program that the „page" 80 is first programmed in CV 6 and the value 200
is immediately programmed in CV 2.

Speed Levels

This decoder can be operated with 14 or 28/128 speed levels (CV 29, Bit 1). Make sure
that the setting on the decoder is compatible with the settings on your controller.
Long Address
This decoder can be controlled in DCC by means of a short (CV 1, address 1 – 127)
or a long address (CV 17 & CV 18, address 1 – 10239). Both addresses are basically
always occupied. CV 29, Bit 5 is used to determine which of the two addresses is
currently valid.
The settings for the long address are calculated as follows:
X = Address / 256 (only the whole number part)
CV 17 = X + 192
CV 18 = Address – (X x 256)
Example:
Address 1324
X = 5 (1324/256=5,17)
CV 17 = 197 (5+192=197)
CV 18 = 44 (5*256=1280; 1324-1280=44)
Value in CV 2

Controllable Functions

Lighting *
Sound effect: High pitched horn
Sound effect: Squealing brakes off
Sound effect: Low pitched horn
Sound effect: Station announcements
Sound effect: compressor
Sound effect: Operating sounds *
Sound effect: Bell
Sound on/off
ABV, off
Sound effect: Conductor whistle
Switching light
Sound effect: Letting off air
Sound effect: sanding
* active in analog operation
The volume can be changed with the rotary control on the circuit board (Figure 1).
The locomotive body must be removed to do this.
The volume can also be changed in digital operation by means of CVs 63, 138 – 155.
SERVICE
Lubrication
The axle bearings should be lubricated occasionally with a small amount of Märklin-
Oil (7149).
Changing Traction Tires
• Remove the axle holder with 6 screws (Fig. 2).
• Remove the wheel set (Be careful with the brake details, The Screws may need to
be resolved at the side covers.)
• Replace the traction tires.
• Reassemble the locomotive.
13
LV
1 Sound 1
2 BS
3 Sound 2
4 Sound 4
5 Sound 11
6 FS
7 Sound 3
8 Sound 16
9
10 Sound 15
11
13 Sound 13
14 Sound 14