Installation Instructions - Novy Comfort 1758-2 Montage- Und Bedienungsanleitung

INSTALLATION INSTRUCTIONS

The installation comes under the exclusive responsibility of specialists.
The installer is held to respect the legislation and the standards enforce in his home country.
How to stick the gasket:
The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.
His installation has to be done carefully, in conformity of the following drawing.
Fitting - installing:
The cut out sizes are:
Cut size
Ref. Width
1758-2 810 mm
• Ensure that there is a distance of 50 mm between the hob and the wall or sides.
• The hobs are classified as "Y" class for heat protection. Ideally the hob should be installed
with plenty of space on either side. There may be a wall at the rear and tall units or a wall
at one side. On the other side, however, no unit or divider must stand higher than
the hob.
• The piece of furniture or the support in which the hob has to be fit, as well as the edges of
furniture, the laminate coatings and the glue used to fix them, must be able to resist
temperatures of up to 100 °C.
• The mural rods of edge must be heat-resisting.
• Not to install the hob to the top of a not ventilated oven or a dishwasher.
• Guarantee a space of 20 mm under the bottom of the hob casing to ensure a good air
circulation of the electronic device.
• If a drawer is placed under the hob, avoid to put into this drawer flammable objects
(for example: sprays) or not heat-resistant objects.
• Materials often used to make worktops expand on contact with water. To protect the cut
out edge, apply a coat of varnish or special sealant. Particular care must be given to
applying the adhesive joint supplied with the hob to prevent any leakage into the
supporting furniture. This gasket guaranties a correct seal when used in conjunction with
smooth work top surfaces.
• The distance between the hob and the cooker
hood placed above must respect the indications
of the hood manufacturer. In case of absence
of instructions respect a minimumdistance of
760 mm.
• The connection cord should be subjected, after
building, with no mechanical constraint, such
for example of the fact of the drawer.
• WARNING: Use only hob guards designed by
the manufacturer of the cooking appliance or
indicated by the manufacturer of the appliance
in the instructions for use as suitable or hob
guards incorporated in the appliance. The use
of inappropriate guards can cause accidents.
Cut size flush mounting
Depth Width
490 mm 904 mm 524 mm 7 mm
Stick the gasket (2) two millimeters
from the external edge of the glass,
after removing the protection sheet (3).
Depth Radius Width
900 mm
71
Glass size
Depth Thickness
520 mm 4 mm