NOTE
In the event of overload or overheating in
non-stop operation, the power tool will
switch off.
To continue working, switch the power tool
off and back on again.
Work instructions
CAUTION!
When the polisher is switched off,
the polishing tool continues running briefly.
NOTE
Following a tool change (e.g. wool pad
instead of polishing sponge), the difference
in weight may increase the vibrations.
Change the operating speed with the
adjusting wheel until the vibrations have
been reduced.
– Switch on the machine before placing it
on the surface which is to be polished
and run the polisher up to the set speed.
– Move the polishing tool without pressure
and make circular, overlapping
movements on the surface to be polished
in order to achieve good polishing results
and to prolong the service life of the tool.
– If using a polishing paste, use the
respective tool for each paste.
For further information on the manufacturer's
products go to www.flex-tools.com.
22
XFE 15 125 18.0-EC / XFE 15 150 18.0-EC / XCE 8 125 18.0-EC
Charger
1
Insertion slot for battery
2
Contacts
3
Ventilation slots
4
Operating state display
5
Power cord with mains plug
The CA 10.8/18.0 charger is designed to
charge FLEX batteries of the following types
– AP 10.8 (2.5 Ah),
– AP 18.0 (2.5 Ah),
– AP 10.8 (5.0 Ah),
– AP 18.0 (5.0 Ah).
Tips for a long battery service life
CAUTION!
Never charge batteries at temperatures
–
below 0 °C or above 55 °C.
Do not charge batteries in environments
–
with high air humidity or ambient
temperature
Do not cover batteries and the charger
–
during the charging process.
Pull out the charger mains plug at the end
–
of the charging process.
Battery and charger heat up during the
charging process. This is perfectly normal!
Lithium-ion batteries do not exhibit the
established "memory effect". Nevertheless,
a battery should be completely discharged
before charging and the charging process
should always be fully completed.
If batteries are not used for an extended
period of time, store them partially charged
in a cool place.