-
Calibration cavity
-
Bluetooth thermal printer
-
Patient response button
-
1 kHz Tone probe license (for Tympanometry)
Reflex – Basic (Stimuli @ 1 kHz) license
-
Reflex – Plus (Stimuli @ 0.5, 1, 2, 4 kHz) license
-
-
Tonal Audiometry Screening License (does not include transducers)
2.2.4
Consumables
-
Thermal paper for the Bluetooth printer (pack of 5)
White earpieces (diam. 6 mm) – 30 pcs.
-
Pink earpieces (diam. 7 mm) – 30 pcs.
-
Purple earpieces (diam. 8 mm) – 30 pcs.
-
Green earpieces (diam. 10 mm) – 30 pcs.
-
Red earpieces (diam. 12 mm) – 30 pcs.
-
Blue earpieces (diam. 14 mm) – 30 pcs.
-
Orange earpieces (diam. 16 mm) – 30 pcs.
-
Sky blue earpieces (diam. 18 mm) – 30 pcs.
-
Yellow earpieces (diam. 21 mm) – 30 pcs.
-
Pack with assorted earpieces – 160 pcs.
-
-
Brushes for cleaning the probe
2.3
P
RECAUTIONS
Installation of the Timpani tympanometer is easy but needs to be done carefully:
incorrect installation could lead to safety issues while using the system.
Like any other electrical or electronic device, the tympanometer will emit
electromagnetic waves. Whilst the level of emissions is guaranteed to be within
statutory limits, other electronic devices operating in the immediate vicinity
could be affected, if particularly sensitive to electromagnetic interference. If this
should occur (interference is verifiable by switching off the instrument and then
switching on again) it may be possible to remedy the problem by adopting one
or more of the following solutions:
-
change the orientation and/or the position of the device affected by
interference;
-
distance the device from the tympanometer.
-
plug the affected device into a power socket on a circuit other than the
circuit to which the tympanometer is connected;
-
consult the manufacturer or a service center for assistance.
8
1