Cleaning And Maintenance; Accessories - eta 231 Serie Bedienungsanleitung

INPUT FILTER REPLACEMENT
To remove the input filter, follow the procedure indicated in Fig. 2. To fit a new input filter in
the vacuum cleaner, proceed in reverse order.
REPLACING THE HEPA FILTER
When removing the HEPA filter, proceed according to Fig. 3. Insert the new/clean HEPA filter
into the vacuum cleaner in a reverse order.
VI. CLEANING AND MAINTENANCE
– For hygienic purposes we recommend that you empty the container and clean the
filters after each use.
– Maximum suction power can be achieved when the filters are clean and the dustbag
is empty.
– Every time you empty the dust container, we recommend that you also clean the filters.
– When you are vacuuming very fine dust, the filter pores might get clogged. This
reduces the air flow and reduces the suction power. In such a case, the filters need to
be cleaned even though the container is not full yet.
Clean the surface of the vacuum cleaner and adaptor with a soft wet cloth. Do not use any
rough and aggressive detergents!

Accessories

After any vacuuming it is recommended to check visually the brushes or collectors for
possible impurities. If there are some impurities, remove them.
Floor nozzle with rotary brush
Remove any dirt (especially hair, animal hairs, etc.) stuck to the brush. To make cleaning
easier, the brush can be removed (Fig. 4).
Dust container
Clean the surface and the inside of the container B with a soft wet cloth. Rinse the separator
B4 under running water. Allow all the parts to dry out properly before their re-use.
Never rinse the container B under running water and never immerse it in water.
It houses electrical components which drive the brush in the floor nozzle Ea/Eb
HEPA filter
Shake out the input HEPA filter A7 gently, or blow it out. If the HEPA filter is very dirty, you
can rinse it under running lukewarm water. Allow it to dry out properly.
– Do not clean the filters with any aggressive washing or cleaning detergents or hot water.
– If you clean the HEPA filter with water, its filtration properties will deteriorate. The filter
cannot be washed more than three times. After that, a new filter needs to be purchased.
– We recommend that you replace the HEPA filter twice a year.
– The filters are not dish-washer safe.
– Failure to clean or replace the filters as required may cause a defect of the vacuum cleaner!
Notes
Caution
and they might get damaged.
Caution
27 / 51
GB