After Driving; Tuning; Spring Preload; Alignment - Reely EP Electro Buggy Buzz 2,0 2WD Bedienungsanleitung

11.2 After driving

Important:
• Always leave the remote control turned on as long as the drive battery is connected to the model.
• Risk of burns! Components heat up during driving. Do not touch battery, motor, drive train and electrical
components right after driving. Let them coold down sufficiently.
Do the following after driving:
1. Set the speed controller switch to OFF.
2. Disconnect the drive battery from the model.
- Let the battery cool down for approx. 10 minutes and then store it in a suitable battery container.
3. Turn off the transmitter.

12. Tuning

12.1 Spring preload

Max Min

12.2 Alignment

The tyres will spread out when the car moves forward, so the alignment when stationary will not be the
same when the car is moving. To optimize steering response and handling, compensate for this by aligning
the tyres with a slight "toe-in". See below for further information.
• The shock absorbers are fitted with a threaded ring to adjust spring tension
(preload). You can increase or decrease the spring tension by adjusting the ring.
• Springs adjusted to the correct length allow the suspension to hold the weight of
the car properly, resist leaning into turns, prevent the chassis from bottoming out,
increase traction, and fine tune the ride height.
• Make sure the preload is the same on both sides.
• Experiment with different settings and positions to get the best results.
29