5. Turn the knife 180° and put it to the second knife notch (k) (figure 2c).
6. As soon as the cutting edge touches the grinding disc, start pulling the knife
towards you until it is fully pulled out of the knife notch. Apply slight
pressure against the grinding disc when pulling out the knife (figure 2b).
7. Check whether the knife is sharpened sufficiently and repeat the
sharpening process if necessary.
8. Switch off the multi task sharpener.
Sharpening of Scissors
1. Install the adapter for sharpening knives and scissors (c) on the multi task
sharpener.
2. Use the on/off switch (b) to put the multi task sharpener into operation.
3. Open the scissors to the full extent.
4. Insert the cutting edge of one scissor blade into the scissor notch (l) so that
the scissors joint and handle of the other cutting edge are facing to the right
(figure 2d).
5. As soon as the cutting edge touches the grinding disc, start pulling the
scissors to the right applying slight pressure on the joint and on the blade.
Do not apply too much pressure against the grinding disc (figure 2e).
6. Turn the scissors 180° and insert the cutting edge of the other scissor
blade into the scissor notch (figure 2f).
7. As soon as the cutting edge touches the grinding disc, start pulling the
scissors to the right applying slight pressure on the joint and on the blade.
Do not apply too much pressure against the grinding disc (figure 2e).
8. Check whether the blades are sharpened sufficiently and repeat the
sharpening process if necessary.
Operation
23