short circuit�
Before cleaning, remove the mains fuse or
switch off the circuit-breaker for the circuit to
isolate the outdoor spotlight from the mains
power supply� Use a voltage tester to check
that the outdoor spotlight is isolated from
the power supply�
Do not immerse the outdoor spotlight in
water�
Make sure that no water gets into the
casing�
RISK OF DAMAGE! Cleaning the outdoor
spotlight incorrectly can potentially cause
damage�
Do not use corrosive cleaning agents,
brushes with metal or nylon bristles or sharp
or metallic cleaning implements such as
knives, hard spatulas or the like� They may
damage the surfaces�
Do not use any chemicals for cleaning�
Switch off the circuit-breaker or remove the
fuse for the circuit�
Use a voltage tester to check that the
outdoor spotlight is isolated from the power
supply�
Allow the outdoor spotlight to completely
cool down�
Wipe down the outdoor spotlight with a
slightly moistened cloth� Allow all parts to
dry completely�
If storing the outdoor spotlight away, keep
it in a dry place where it is safely out of the
reach of children�
z Troubleshooting
= Fault
= Cause
= Solution
= The outdoor spotlight fails to function�
= There is a fault with the power supply
or cable�
= Have it checked by a competent
person�
= The outdoor spotlight is incorrectly
adjusted�
= Use the control knobs to adjust the
settings properly�
= The wiring is incorrect�
= Have it checked by a competent
person�
= The detection range of the motion
sensor is badly adjusted�
= Readjust the detection range of the
motion sensor�
= The outdoor spotlight constantly
switches on and off�
= The outdoor spotlight constantly
responds to movement�
= Check the detection zone for moving
objects/animals�
= Check the adjustment of the outdoor
spotlight�
= Readjust the detection range of the
motion sensor�
= Adjust the illumination time�
= Adjust the sensitivity of the twilight
sensor�
= The outdoor spotlight gets hot�
= That is quite normal and not a fault�
= Make sure that the outdoor spotlight
is well ventilated�
Please note! Any other repairs may only be
carried out by a qualified electrician.
z Disposal
Note the labels on the packaging
materials when sorting the waste;
they are marked with abbreviations
(a) and numbers (b) with the
following meanings:
1-7:
Plastics
20-22:
Paper and cardboard
80-98:
Composite materials
You can find out how to dispose of
the used product by contacting your
11
GB/CY