Before First Use; Setting Up The Battery Charger; Charging The Battery - Westfalia ASS18 Originalanleitung

Operation

Before first Use

Unpack the saw and check the unit for any damage in transit. Dispose of
packaging materials or store it out of reach of children. Plastic bags etc.
may become a deadly toy for children.
Please note that that battery and charger are not included with the tool!
Setting up the Battery Charger – (Battery and Charger not included)
1. If fitted, remove the battery from the battery charger.
2. Insert the battery charger mains plug into a suitable mains socket.
Note: One LED on the charger will indicate ready status. For further in-
formation please refer to the included manual of the included charger.
WARNING: Only use this charger to charge compatible batteries that are
specifically designed for this tool.
WARNING: The charger is designed for indoor use only, and must not
be used in damp or wet conditions.

Charging the Battery

WARNING: Failure to follow the correct procedure when charging bat-
teries will result in permanent damage.
Note: Normal charging time is 1 hour for a recently discharged battery.
However, if the battery (1) has been left in a discharged state for some
time, it may take up to 1.5 hours to charge.
1. Slide a fully or partially discharged battery onto the battery charger.
2. Once charging commences, the red LED will illuminate.
3. When the battery is fully charged, the green LED will illuminate.
If the battery is defective the red LED flashes!
Note: Make sure the battery and battery charger are lined up correctly. If
the battery does not slide onto the battery charger easily, do not force it.
Instead, remove the battery, check the top of battery and the battery
charger slot are clean and undamaged and that the contacts are not
bent.
20