Westfalia 64 16 05 Originalanleitung Seite 13

Installing/Replacing the Sanding Belt
Disconnect the unit from power mains.
1. Slacken the sanding arm by folding the tensioning lever
(8) forward.
2. Insert the sanding belt (11) into the housing. Guide the
sanding belt behind the cover (5). Please follow the
rotating direction arrow on the sanding belt and the cover. The direction
arrows have to be in the same direction.
3. Tension the sanding belt with the tensioning
lever (8) by turning back.
4. Start up the power file at the lowest speed –
speed regulator (2) must be set to position 1 –
and adjust the position of the sanding belt by turning the regulating turn knob
(7). Adjust the sanding belt in such a way that the belt does not walk off the
front pulley to one side.
Turning ON and OFF
1. The power file is turned on with the ON/OFF switch (1). When the switch is
pressed, the power file starts up and runs with the preset speed on the speed
regulator (2).
2. To turn the power file off, release the ON/OFF switch (1). For continuous use,
the switch can be locked in place with the locking button (9). Press the
ON/OFF switch and than press the locking button. Now the ON/OFF switch is
locked and can be released.
3. To release the locking, first press the ON/OFF switch (1). The locking button
lightly jumps out of the housing and the power file turns off after releasing
the ON/OFF switch.
Regulating the Speed
The speed of the power file can be regulated with the speed
regulator (2) in order to match the material which is to be
machined.
1. Turn the regulator to the position 1 for low speed (1070 m/min
1
) and to the position 6 for max. speed (1650 m/min
2. During operation it is also possible to infinitely adjust the speed
with the sped regulator.
13
-
-1
).