Optional Accessories - Makita PV7000C Betriebsanleitung

Installing or removing wool bonnet
Optional accessory
► Fig.8: 1. Wool bonnet 2. Lock nut 3. Rubber pad
4. Spindle
1.
Mount the rubber pad onto the spindle. Screw the
lock nut onto the spindle.
2. To tighten the lock nut, hold the spindle with the
wrench so that the spindle cannot revolve, then use the
lock nut wrench and securely tighten clockwise.
► Fig.9: 1. Lock nut wrench 2. Wrench
3. Fit the wool bonnet completely over the rubber
pad, and pull the string tight. Tie a bow knot and tuck
the knot and any loose strings between the wool bonnet
and the rubber pad.
► Fig.10
To remove the wool bonnet, follow the installation pro-
cedure in reverse.
OPERATION
CAUTION:
Always wear safety goggles or a
face shield during operation.
CAUTION:
ALWAYS hold the tool firmly with
one hand on housing and the other on the side
grip (handle).
Polishing operation by sponge pad
► Fig.11
In general, keep the sponge pad at an angle of about 15
degrees to the workpiece surface.
Polishing operation by wool bonnet
► Fig.12
Turn the tool on and then apply the wool bonnet to the workpiece.
In general, keep the wool bonnet at an angle of about
15 degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will
result in poor performance and premature wear to the
wool bonnet.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Replacing carbon brushes
► Fig.13: 1. Limit mark
Check the carbon brushes regularly.
Replace them when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
1. Use a screwdriver to remove the brush holder
caps.
2. Take out the worn carbon brushes, insert the new
ones and secure the brush holder caps.
► Fig.14: 1. Brush holder cap 2. Screwdriver
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Side grip
• Sponge pad (hook-and-loop)
• Backing pad 165 (hook-and-loop)
• Wool bonnet 180
• Wrench
• Rubber pad
• Lock nut
• Lock nut wrench
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
8 ENGLISH