Working Without The Automatic Leveller; Working With The Clamp Tripod - Parkside PKLL 7 E4 Originalbetriebsanleitung

GB IE
Red: if automatic level-
ling is not possible.
The laser lines will flash
and longer be at exact
right-angles to one
another.
4. Switch the device off by
locking the levelling stop:
position
In the event of vibra-
tions, the laser will level
itself automatically; wait until
the laser lines no longer
move.
Working without the
automatic leveller
Caution! - Laser beam.
Do not look into the
beam. Turn your head away
or close your eyes to prevent
looking into the laser beam.
Danger of eye injury!
The LED ring (2) will il-
luminate permanently
in red when working without
the automatic leveller. The la-
ser lines depicted are not le-
velled.
10
.
Switching on:
Turn the device on using
the on/off switch (1). The
levelling stop (4) must be in
position .
Switching off:
Turn the device off using the
on/off switch (1).
Working with the
clamp tripod
The clamp tripod provided
can be used to attach the de-
vice to various objects.
1. Release the clamping
nut (9).
2. Position the clamping
jaws (10) to the desired
location.
3. Turn the clamping nut (9)
until fastened.
4. Place the device with
thread (5) onto the tripod
screw (7) and tighten by
hand.
Do not use excessive
force as this may dama-
ge the device.