Using Individual Lines And Crossed Lines; Working Without The Automatic Levelling System; Practical Guidance - Parkside PKLL 10 B3 Originalbetriebsanleitung

Note: if the product is agitated or its position is changed during
operation, the product will automatically re-level. After re-levelling
check the positions of the horizontal and vertical laser lines against
reference points to avoid errors.

Using individual lines and crossed lines

When the product is performing automatic levelling and the base
of the measurement device deviates from the horizontal by less
than 4° (green LED on), carefully press the H-button
horizontal line on or off.
Or correspondingly press the V-button
on or off.
Crossed lines can be locked with this product:
When the product is performing automatic levelling and the base
of the measurement device deviates from the horizontal by less than
4° (green LED on) hold down the H-button
tor goes red. Now automatic levelling is switched off and the
2
crossed lines are permanently switched on - even if the base of the
measurement device deviates from the horizontal by more than 4°.
You can turn this mode off again by pressing and holding down the
H-button
1
matic levelling system has been switched on again.
The crossed lines are turned off as soon as the base of the measuring tool
deviates from the horizontal by more than 4°, and the LED indicator
will turn red again.
Working without the automatic
levelling system
Put the LOCK switch
Hold down the H-button
on. Now the product will release two laser lines from the laser
beam opening
levelling will always be indicated via the red LED indicator

Practical guidance

Always use only the middle of the laser line for markings. The width
of the line depends on the distance.
until the LED indicator
into the position .
4
until the red LED indicator
1
that are not levelled. Operation without automatic
7
to turn the vertical line
3
until the LED indica-
1
goes green again. The auto-
2
to turn the
1
2
comes
2
.
2
GB/IE 25