Additional Safety Instructions - Parkside PAHE 20-Li B2 Originalbetriebsanleitung

GB IE
• Each of these reactions can lead
to you losing control of the saw
and potentially being seriously
injured. Do not rely exclusively on
the safety devices built into the
chainsaw. As user of the chain-
saw, you should undertake various
measures to enable accident- and
injury-free working.
A kickback is caused by wrongly
or incorrectly operating the electric
tool. It can be avoided by suitable
cautionary measures, such as de-
scribed below:
• Hold the saw firmly with
both hands with thumbs
and fingers surrounding
the chainsaw handles. Pla-
ce your body and arms in
a position where you can
withstand the kickback
forces. The user will be capab-
le of withstanding the kickback
forces if suitable measures are
undertaken. Never let go of the
chainsaw.
• Avoid an abnormal body
posture. This will enable better
control over the chainsaw in un-
foreseen situations.
• Always use the replace-
ment rails and saw chains
specified by the manufac-
turer. Incorrect replacement
rails and saw chains can cause
the chain to break apart and/or
may lead to kickback.
• Comply with the manu-
facturer's instructions for
sharpening and main-
taining the saw chain.
Depth limiters placed too low
36
increase the potential for kick-
backs.
• Do not saw with the tip of
the blade bar (see Fig. b).
There is a risk of kickback.
• Ensure there are no ob-
jects on the ground which
could cause you to stumb-
le.
Additional safety
instructions
• Hold the power tool only by the
insulated gripping surfaces as
the cutting blade may come into
contact with concealed power
lines. Contact with a live wire
can also cause a charge in me-
tal parts of the appliance and
result in an electric shock.
• Carefully inspect the surface to
be cut, and remove all wires
and other foreign bodies.
• Check the appliance before
each use for obvious defects
such as loose, worn or dama-
ged parts. Check the appliance
for significant damage or de-
fects if it is dropped.
• If the device has been dropped
or struck, you must check the
device before starting it and en-
sure it is in a good condition.
• Caution! Local regulations may
restrict use of the machine.
• Always maintain the device and
cutting tool in a good condition.
• Observe the following: Impro-
per maintenance, the use of
non-compliant spare parts or the
unauthorised removal or modifi-
cation of safety equipment can
lead to damage to the device