Bleed Floor Jack; Lifting The Vehicle - Westfalia T82004 Bedienungsanleitung

Bleed the Trolley Jack
Air bubbles may enter into the hydraulic system and interfere the function. In this
case it would be either difficult to lift up the trolley jack or the trolley jack will
abruptly lift up or down.
1. To bleed the hydraulic cylinder, close the release valve (7) completely.
2. Pump up the trolley jack with the pumping handle (1).
3. Open the release valve (7) and slowly press the saddle (5) completely down.
4. Close the release valve (7).
After this the trolley jack should work easily and correctly. If not, repeat bleed
process.

Lifting the Vehicle

1. If the release valve (7) is opened, close it by inserting the pumping handle on
the valve and turning clockwise as far as it will go.
2. Make sure the vehicle cannot roll. Place the trolley jack centrally under the
vehicle lifting point. Lift up the saddle of the trolley jack by using the pumping
handle.
3. Place the saddle under the intended vehicle lifting point. For further
information, read the vehicle handbook.
4. Insert the pumping handle (1) into the handle socket
(2) and make a ¼-turn in order to lock the handle. As
the handle socket can be rotated to 360°, the socket
can be used at any desired position.
5. Pump up the trolley jack by using the pumping handle
and pump one to three times until the saddle (5) is
secured in the central position of the vehicle lifting
point. Lift the vehicle up to the desired working height.
6. Immediately secure the lifted vehicle with blocks. Never work under the
vehicle if it is lifted up by the trolley jack only. During work, observe the saddle
(5) and the vehicle lifting point in order to recognize any movements.
All manuals and user guides at all-guides.com
Using
15