Safety Notices For Milling Cutters - Parkside POFA 12 A2 Originalbetriebsanleitung

c) Keep the unused battery away
from paper clips, coins, keys,
nails, screws and other small
metal objects, which could
cause bridging of the contacts.
A short circuit between the battery con-
tacts may cause burns or fire.
d) If used incorrectly, liquid may
leak from the battery. Avoid
contact with this. In the event of
accidental contact, rinse off with
water. If the liquid gets into
eyes, seek medical assistance.
Leaking battery fluid may cause skin
irritations or burns.
e) Do not use damaged or altered
batteries. Damaged or altered batter-
ies can be unpredictable and lead to
fire, explosion or risk of injury.
f) Do not expose batteries to fire
or elevated temperatures. Fire or
temperatures over 130°C can cause
an explosion.
g) Follow all instructions for charg-
ing and never charge the bat-
tery or the battery-powered
tool outside the temperature
range stated in the operating
instructions. Incorrect charging or
charging outside the permitted tem-
perature range may destroy the battery
and increase the risk of fire.
6) SERVICE
a) Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.
b) Never repair damaged batter-
ies. All battery repairs should be car-
ried out by the manufacturer or author-
ised customer service centres only.
Safety notices for milling
cutters
Warning! Milling can result in
the formation of dusts hazardous to
health, which can pose a risk to the
operator or persons nearby.
Make sure that the workplace is
well ventilated. Always wear safety
goggles and respiratory protection.
Attach a dust extraction system.
Materials hazardous to
health such as lead, materi-
als coated in paint containing
lead or materials containing
asbestos may not be worked
on using this device!
• Fasten and secure the workpiece
by means of clamps or with
another method on a stable un-
derground. If you hold the workpiece
only with your hand or against your own
body, it will stay instable and this can
lead to a loss of control.
• The permissible rotation speed of
the attachment tools must be at
least as high as the highest rota-
tion speed indicated on the pow-
er tool. Accessories that run faster than
the permissible speed can be destroyed.
• Cutters and other accessories
must be exactly matching the
tool holder (collet chuck) of your
power tool. Attachment tools that are
not exactly matching the tool holder of
the power tool rotate unevenly, vibrate
very strongly and can ultimately lead to
a loss of control.
• Ensure that the cutter is assem-
bled correctly. A cutter that is not as-
sembled correctly can break during the
milling or be ejected and present a risk
GB IE
29