7. Before you start
7.1 Mounting
Step 1
Place the nuts (15) into the recess on the
bottom spacers (3).
Insert the bottom spacers (3) into the
watering unit (4).
Step 3
Insert the top spacers (2) and the nuts (15)
into the recess on the LED hood (1).
Screw the screws [M8 x 12] (14) into the
LED hood (1).
CAUTION! Make sure you used the short
screws [M8 x 12] (14).
Step 2
Screw the screws [M8 x 16] (13) into the
watering unit (4).
Place the holding plate (7) onto the watering
unit (4).
Step 4
Insert the top spacers (2) into the lower
spacers (3).
Secure the parts using the screws [M8 x 16]
(13) and nuts (15).
Parkside PPL 10 A1
English - 27