Mounting The Suction Adapter; Inserting/Changing Cutters; Mounting The Parallel Stop; Adjust Cutting Depth - Parkside POFA 12 A1 Originalbetriebsanleitung

3. Release the spindle locking button (10).
4. Take out the 8 mm collet chuck (12)
using pliers and insert the 6 mm collet
chuck (20) that is included in the deli-
very. You will hear it click into place.
5. Screw the cap nut (11) loosely back
on.
Tighten the cap nut only when a
cutter is inserted. The collet chuck
might get damaged.
Mounting the suction
adapter
You can reduce dust formation while you
work by connecting a dust suction system.
1. Unlock the cutting depth rough adjust-
ment by turning the locking knob (16)
anticlockwise about half way.
2. Press and hold the cutting depth rough
adjustment button (6).
3. Now move the drive unit (5) fully up
to the top. The drive unit (5) and ba-
seplate (9) are now at the maximum
distance from one another.
4. Let go of the button (6).
5. Fit the suction adapter (21) into the reces-
ses provided (13) in the baseplate (9).
6. To lock, turn the suction adapter (21)
clockwise as far as it allows.
4. Connect the suction hose of a vacuum
cleaner to the suction adaptor (21).
The vacuum cleaner must be
suitable for the workpiece to be
processed. Use a special vacuum
cleaner if dusts with hazard for
health are created.
Inserting/changing
cutters
To insert and replace cutters, wear
protective gloves to prevent cuts
and burns.
1. Press the spindle locking button (10)
on the side of the device and keep it
pressed down.
2. Use the combination wrench (19) to
loosen the cap nut (11) as much as nee-
ded, so that the cutter can be inserted.
3. Release the spindle locking button (10).
4. Insert the desired cutter into the already
mounted collet chuck (12). The cutter
shaft must be pushed in at least 20 mm.
5. Use the combination wrench (19) to
tighten the cap nut (11) while kee-
ping the spindle locking button (10)
pressed.
Tighten the cap nut only when a
cutter is inserted. The collet chuck
might get damaged.

Mounting the parallel stop

1. Unscrew both retaining screws (15) on
the top side of the baseplate.
2. Now insert the parallel stop (22) into
the receptor (14) provided on the base-
plate (9).
3. Fix the parallel stop into the desired
position using the retaining screws (15).

Adjust cutting depth

The cutting depth may only
be set when the device is
switched off
GB MT
51