RID16
6
Operating the field indicator
6.1
Quick operation guide
Operators have two options for configuring and commissioning the device:
1. Configuration programs
Device-specific parameters are configured via the E+H Service interface (CDI). A special device
driver (DTM) for an FDT operating program (e.g. DeviceCare, FieldCare) is available for this pur-
pose ä 41
2. Miniature switches (DIP switches) for local configuration
You can make the following settings for the PROFIBUS® PA interface using miniature switches
(DIP switches) on the rear of the display:
• Setting to specify whether operation is possible via DIP switches or remotely via the DTM
• Setting for the address of the bus users whose values are to be displayed
• Configuring an offset
More information on the hardware settings via DIP switches ä 41.
Abb. 10: Hardware setting via DIP switches
1
ON switch position
2
OFF switch position
3
Write protection
Only 2 display values can be configured when operating via the DIP switches.
Endress+Hauser
Operating the field indicator
A0021500
39