Improper Use; Personnel Qualifications - Bosch Rexroth EC302 Montageanleitung

EC30X | 3 609 929 728/2014-01
2.3

Improper use

Any other use
• than that described in the intended use
and
• than that described in the respective do-
cumentation
is regarded as unintended use and is there-
fore inadmissible.
Bosch Rexroth AG will not accept any liabi-
lity for damage caused by the unintended
use. The risks in case of unintended use are
exclusively borne by the user.
The unintended use of the product and its
components (if available) includes:
• that it is subjected to operating condi-
tions that do not fulfill the specified ambi-
ent conditions. Operation is forbidden
e.g. under water, with extreme air humi-
dity, under extreme temperature fluctua-
tions, or under extreme maximum tempe-
ratures.
• that it is used in applications that have not
been explicitly approved by
Bosch Rexroth AG. Always observe the
safety instructions in the respective docu-
mentation.
• the structural change destroying the ori-
ginal state.
• the improper programming or configura-
tion of the tightening system.
The user is solely responsible for risks
caused by programming and configura-
tion of the tightening system.
2.4

Personnel qualifications

Assembly, commissioning, maintenance,
troubleshooting and disassembly of this
Rexroth product and the handling of the
product require basic electrical and mecha-
nical knowledge, as well as knowledge of
Bosch Rexroth AG
the appropriate technical terms. Handling of
the product includes e.g. completion of a
Rexroth tightening spindle from the compo-
nents and the installation of a Rexroth tigh-
tening spindle into a system.
In order to ensure the safe use, the speci-
fied activities may therefore only be carried
out by qualified technical personnel or an in-
structed person under the direction and su-
pervision of qualified personnel.
In other words, only appropriately trained
and qualified personnel are permitted to
work with or near the product during the as-
sembly, commissioning, maintenance, trou-
bleshooting and disassembly.
Qualified personnel
• are those who can recognize possible ha-
zards and institute the appropriate safety
measures due to their professional trai-
ning, knowledge, and experience as well
as their understanding of the relevant
conditions pertaining to the work to be
done.
• must observe the rules relevant to the
subject area.
• must be trained, instructed, and authori-
zed to switch electrical circuits and de-
vices on and off in accordance with the
accepted rules of safety and current tech-
nology, ground them, and mark them ac-
cording to the job requirements.
• must be sufficiently familiar with all war-
nings and precautions according to this
documentation and the documentation of
the respective component and under-
stand their content.
• must have appropriate safety equipment
and be trained in first aid.
Persons who assemble, operate, disassem-
ble, or maintain products from Bosch
Rexroth AG must not consume any alcohol,
43/72