IKEA NUTID MWC6 Anleitung Seite 9

ENGLISH
This is done by selecting a Doneness level
with the adjust knob right after you have
pressed the Start button.
NOTE:
The doneness can only be set or altered
during the first 20 seconds of operation.
Doneness
Level Effect
H 2 YIELDS HIGHEST END
TEMPERATURE
H 1 YIELDS HIGHER END
TEMPERATURE
- - - - DEFAULT STANDARD SETTING
Lo1 YIELDS LOWER END
TEMPERATURE
Lo2 YIELDS LOWEST END
TEMPERATURE
Cooling down
When a function is finished,the oven carries
out a cooling procedure.
This is normal.
After this procedure the oven switches off
automatically.
The cooling procedure can be interrupted
without any harm to the oven by opening
the door.
Kitchen timer
Use this function when you need a kitchen
timer to measure exact time for various
purposes such as cooking eggs or letting the
dough rise before baking etc.
1
1. Turn the multifunction knob to zero
position.
2. Turn the adjust knob to set the time to
measure.
The timer automatically starts the
countdown after 1 second.
An acoustic signal will be heard when the
timer has finished to count down.
Clock
When the appliance is first plugged in or
after a power failure, the display is blank. If
the clock is not set, the display will remain
blank until the cooking time is set.
1
1. Turn the multifunction knob to zero
position.
2. Press the select button (3 seconds) until
the left-hand digit (hour's) flicker.
3. Turn the adjust knob +/- to set the hours.
4. Press the select button again. (The two
right hand digits (minutes) flicker).
5. Turn the adjust knob to set the minutes.
6. Press the select button again.
The clock is set and in operation.
If you wish to remove the clock from the
display once it has been set, simply press
the Select button again for 3 seconds and
then press the Stop button.
To reinstate the clock , follow the above
procedure.
NOTE: keep the door openwhile setting the
clock. This gives you 10 minutes to complete
the setting of the Clock. Otherwise, each
step must be accomplished within 60
seconds.
2
9
2/4/6 3/5