Panasonic nanoe X CZ-CNEXU1 Bedienungsanleitung Seite 6

nanoe™ X Function
„ Internal Cleaning Operation
When cooling or dry operation stopped, internal drying and nanoe™ X circulation airflow is
activated in order to suppress the mold proliferation inside the unit (airflow passage, fan, heat
exchanger). According to the installation environment or operating hours, mold proliferation or
inhibition of mold growth will be changed.
Internal drying of inside unit
Fan rotation and internal dehumidifying
z Operating conditions and operating hours
z
Operates in cooling or dry mode for more than 5 minutes.
When finished, the internal cleaning operation is started.
Drives for about Max 75 minutes.
z The figure at right shows the display during the internal
z
cleaning operation.
z If you wish to resume operating during internal cleaning,
z
press .
„ To stop the internal cleaning operation
Press .
z When the internal cleaning operation finished and stopped,
z
the remote control display shows at right.
NOTES:
z Internal cleaning function is not possible to use any remote controller other than that of
z
nanoe™ X function.
z When connected to the remote controller which is adaptable to the nanoe™ X function, the
z
internal cleaning function is set to work automatically. If you wish to set to OFF, see page 8.
z In case that the operation time of the air conditioner is less than 5 minutes, the internal
z
cleaning operation cannot be performed.
z While the internal cleaning operation is running, the indoor temperature may occasionally
z
increase.
6
Internal Cleaning Function
Internal Cleaning Operation
nanoe™ X cycle of inside unit
Fan rotation and nanoe™ X internal circulation