Using The Angle Setting Device With Laser - Westfalia 83 82 06 Bedienungsanleitung

Using the Angle Setting Device with Laser

1. With the use of the angle setting
device and the built-in laser
beam you can mark any angle
from 0 – 180° (90° – 0 – 90°) on
any object or a wall.
2. To move the angle setting device
freely on the scale body, first
slightly loosen
screws (9) by turning counter
clockwise.
3. Position the arrow (outlined in blue on the pictures) exactly to the
position 0° and re-tighten the locking screws (9) hand tight.
4. To adjust the angle setting device to
the desired angle, turn the locking
screw (12) in direction to the opened
padlock symbols. Now the angle set-
ting device is released and can be
turned freely.
5. Adjust the desired angle by turning the
angle setting device to the left or to the right. Always make sure
that the arrow (outlined in blue) is exactly on the position 0°.
6. Push the ON/OFF switch of the angle
setting device (11) in order to draw the
laser beam on the object/the wall. Al-
so activate the laser beam of the laser
level by pressing the ON/OFF switch
(13). Now you can clearly see the an-
gle (α).
7. Mark the drilling hole position or the
line on the object/the wall. After work switch off the laser beams.
Using
both locking
16
α = 40°