Safety Regulations - EINHELL BT-KF 150 Originalbetriebsanleitung

Danger!
When using the equipment, a few safety precautions must be observed to avoid
injuries and damage. Please read the complete operating instructions and safety
regulations with due care. Keep this manual in a safe place, so that the information
is available at all times. If you give the equipment to any other person, hand over
these operating instructions and safety regulations as well. We cannot accept any
liability for damage or accidents which arise due to a failure to follow these instruc-
tions and the safety instructions.

1. Safety regulations

General safety instructions for electric tools
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regulations and instructions may result in
an electric shock, fi re and/or serious injury.
Keep all safety regulations and instructions in a safe place for future use.
The term "electric tool" used in the safety instructions refers to electric tools opera-
ted from the mains power supply (with a power cable) and to battery operated elec-
tric tools (without a power cable).
1. Workplace safety
a) Keep your work area clean and well illuminated. Untidy or unlit work areas
can result in accidents.
b) Do not operate the electric tool in an environment where there is a risk of
explosions and where there are infl ammable liquids, gases or dust. Elec-
tric tools produce sparks which could set the dust or vapours alight.
c) Keep the electric tool out of the reach of children and other persons. If
there is a distraction, you may lose control of the appliance.
2. Electrical safety
a) The connector plug from this electric tool must fi t into the socket. The
plug should never be altered in any way. Never use adapter plugs to-
gether with earthed electric tools. Unaltered plugs and correct sockets redu-
ce the risk of an electric shock.
b) Avoid bodily contact with earthed surfaces such as pipes, heating,
ovens and fridges. The risk of electric shock is increased if your body is
earthed.
c) Keep the tool out of the rain and away from moisture. The ingress of water
into an electric tool increases the risk of an electric shock.
Anl_BT_KF_150_SPK7.indb 24 Anl_BT_KF_150_SPK7.indb 24
GB
- 24 -
23.06.2016 09:28:58 23.06.2016 09:28:58