Installation; General Information; Mounting Of The Warning Device - Pepperl+Fuchs NVOR-200 Handbuch

INTERFACE

Installation

3 Installation
3.1

General information

Before mounting the sensor, read the chapter on "Safety," in particular the section on
"Installation and commissioning" (see chapter 1.7). Do not remove the identification plate.
Warning!
Risk of short circuit
Injuries and damage to the device are possible when working with live parts.
• Before working on the device, always disconnect the supply voltage.
• Connect the device to the supply voltage only after completion of the work.
During installation, read and follow the instructions of the system manufacturer and the smoke
detector manufacturer.
Note!
For further information on installing the sensor, please refer to the manuals for the sensors.
3.2

Mounting of the warning device

Note!
If the device is installed in a housing or switch cabinet, note the mounting instructions of the
housing or switch cabinet manufacturer.
Caution!
Overheating
If outside temperature exceeds 40 °C with maximum load, this may result in damage to the
device.
• Ensure there is sufficient ventilation at the place of installation.
• Observe a minimum clearance of 5 mm between devices on the DIN rail.
EN
EN - 7