Faller 161668 Handbuch Seite 5

IMPORTANT:
e.g.:
There is a remaining amount of 516 mA for components to be activated by "buttons".
These are:
Application:
Functioning:
A Rectifier
Art. No.: 161675
Art. No.: 161677
Art. No.: 161676
Art. No.: 161674
Art. No.:16168 ..
B Connection diagram
Button T ...
Switch S ...
Technical data:
161668 rectifier
It is also possible to connect more components than specified above, if the sum of the
of the "ACTIVE components"
20 stop points, of which 10 pcs. are "ACTIVE"
20 branches, electrical, of which 8 pcs. are "ACTIVE"
3 pcs. of stop points or
3 pcs. of branches or
2 pcs. - one stop point and one
Manual control of the FALLER car-system
It transforms AC into DC.
The rectifier is connected to a transformer 12 -16 VAC,
e.g. FALLER transformer Art. No. 180641.
Switching of the individual components by:
Stop point Switch
Branch, electrical Button (without series resistor) or
Switch (with 47-Ohm series resistor)
Branch Button
Parking lot Button
Magnet enable coil Button
Various examples for FALLER car-system components.
Instantaneous switch
Continuous - ON / OFF
Input voltage 12 - 16VAC
Current input up to 3000 mA AC (5 - 10 minutes)
Output voltage at 12 VAC
(unloaded) at 16 VAC
Max. continuous current loading 2500 mA DC
does not exceed 2500 mA.
10 x 138 mA = 1380 mA
SUM =
branch
Voltage only as long as button is operated.
Voltage is permanently ON / OFF.
approx. 16.9 VDC
approx. 22.6 VDC
8 x 138 mA = 1104 mA
2484 mA
5
"required power"