Setting The Alarm Recording Mode - Sony SVT-72P Bedienungsanleitung

5
Press MENU V to move the flashing to the setting
of ALARM DURATION and set 20sec, 40sec,
1min, 2min, 3min, 4min, 5min or CC by pressing
MENU + or –.
ALARM SET
ALARM MODE
ALARM SPEED
ALARM DURATION
ALARM DATA REC
TAPE END WARN.
CLOG DETECTION
SERIES REC
< >
NEXT PUSH
+ –
SELECT : DATA SET : / RETURN : MENU
20sec - 5min: for recording for 20 seconds, 40
seconds, 1 minute, 2 minutes, 3 minutes, 4
minutes or 5 minutes
CC: for recording as long as the alarm signal is
being input
6
Press SEARCH to return to the normal display.
To return to the MAIN MENU screen from the
current menu
Press MENU again.
To go to the next menu from the current menu
Press MENU V until "NEXT PUSH B" flashes and
press MENU B.
Setting the Alarm Recording
Mode
1
Turn on the power of the equipment to be used.
2
Press MENU and MENU V until "3" of the MAIN
MENU flashes on the monitor screen.
3
Press MENU B.
The ALARM SET menu appears.
ALARM SET
ALARM MODE
ALARM SPEED
ALARM DURATION
ALARM DATA REC
TAPE END WARN.
CLOG DETECTION
SERIES REC
< >
NEXT PUSH
+ –
SELECT : DATA SET : / RETURN : MENU
A1
3H
40sec
OFF
COUNTER
ON
OFF
A1
3H
20sec
OFF
COUNTER
ON
OFF
4
Set ALARM MODE to A1, A2, A3 or OFF by
pressing MENU + or –.
A (alarm)1: always accepts alarms.
A2: accepts alarms only when timer recording is
proceeding.
A3: accepts alarms only when timer recording is
not proceeding.
OFF: does not accept alarm even if an alarm
signal is received.
5
Press SEARCH to return to the normal display.
To return to the MAIN MENU screen from the
current menu
Press MENU again.
To go to the next menu from the current menu
Press MENU V until "NEXT PUSH B" flashes and
press MENU B.
Notes
• While alarm recording is in progress, other modes are
inoperable.
• After the alarm recording is completed, the VCR
returns to the condition it was in before the alarm
signal was received.
• If an alarm input is received while the VCR is in
repeat recording (see page 20), repeat recording stops
and the REPEAT indicator goes out. After the tape
reaches the end, the tape is rewound and the VCR
stops. The OFF indicator lights in the display window
(only when REPEAT 1 is selected for TAPE END
MODE in the GENERAL SET menu).
• When the OFF indicator lights, in order to prevent
accidental erasure of a recorded tape, timer recording
and alarm recording cannot be executed.
If any of REC z, FF M, REW m, PLAY B,
STOP x is pressed, the OFF indicator goes out.
• If another alarm is received while alarm recording is
in progress, the second alarm recording starts and the
recording duration is extended.
• If the power is interrupted while alarm recording is in
progress and restored again, the operation before the
alarm recording was made resumes.
33