Bosch VLE 2130 Erstinbetriebnahme Seite 23

4.4.2 Setting lower cut-out points
1. Set the encoding switch to "4".
2. Confirm with <ENTER>.
 LED1 flashes green.
 Main column single traverse mode selected.
!
Automatic cut-out on reaching the cut-out points is
not active in mode "4". Do not move as far as the
stop, as otherwise the lifting carriage will jam on
the lifting spindle and the loadbearing nut will be
damaged.
3. Turn the rotary reversing switch to the left (lowering).
 The main column support arms move downwards.
 Lower the support arms until there is a clearance
of at least 25 mm (10 mm safety and approx.
15 mm run-on reserve) between the lowest point
of the support arm and the floor.
4. Set the encoding switch to "1".
5. Confirm with <ENTER>.
 LED 1 and LED 2 flash simultaneously (green).
6. Confirm with <ENTER>.
 LED 1 and LED 2 flash alternately (green).
"
The lower cut-out points have been stored.
i
If the cut-out points are too high, they can be mo-
ved downwards by 15 mm (run-on) in each case by
repeating the steps.
4.4.3 Setting upper cut-out points
1. Set the encoding switch to "0".
2. Confirm with <ENTER>.
 This selects operating mode.
3. Turn the rotary reversing switch to the right (raise).
 The main column and secondary column support
arms move upwards.
4. Move the support arms jointly upwards to the
maximum height of 1900 mm between the lower edge of the
support arms and the top edge of the column base
plate.
!
The setting for the upper cut-out point also depends
on the ceiling height and maximum height of the
vehicles to be raised.
5. Set the encoding switch to "3".
6. Confirm with <ENTER>.
 LED1 and LED2 light (green).
7. Confirm with <ENTER>.
 LED1 and LED2 flash (green).
"
The upper cut-out points have been stored.
Robert Bosch GmbH
Installation | VLE 2130 / 2130 F | 23
4.4.4 Setting safety stop
1. Set the encoding switch to "0".
2. Confirm with <ENTER>.
 This selects operating mode.
3. Turn the rotary reversing switch to the left (lowe-
ring).
 The main column and secondary column support
arms move downwards.
4. Move the support arms together downwards to the
required height (200 mm between lower edge of support
arms and floor).
5. Set the encoding switch to "6".
6. Confirm with <ENTER>.
 LED 1 and LED 2 flash simultaneously (green).
7. Confirm with <ENTER>.
 LED 1 and LED 2 flash alternately (green).
"
The safety stop position has been stored.
4.4.5 Finish Settings
1. Set the encoding switch to "0".
2. Confirm with <ENTER>.
 This selects operating mode.
3. Check raising and lowering of the support arms and
the cut-out position.
"
This completes setting.
en
|
1 689 978 550 2017-07-14