Klarstein 10009349 Bedienungsanleitung Seite 12

Note: 1. Toasting process can be terminated at any time by pressing the "Cancel" button.
2. Only the power supply is switching on, the carriage handle can rest on the bottom of slot.
7. During the toasted process, you may observe the toasting color, if it is satisfying; you press the
"Cancel" button to cancel the operation at any time.
8. Once the bread has been toasted to the preset color, the carriage handle will automatically spring
up. The lamp on the "Cancel" button will be extinguished.
9. If you want to reheat the cold toasted bread, press the "Reheat" button and the lamp on it will be
illuminated. In this mode toasting time is fixed, so long as time is running over, the carriage
handle will automatically spring up and end up the reheating process.
10. If the bread has been taken out from refrigerator, set color control knob to your desired color,
press carriage handle down vertically until it is positioned in place, press "Defrost" button and
the lamp on it will be illuminated, in this mode it will be toasted to your desired color.
Caution:
1. If toaster starts to smoke, Press "Cancel" to stop toasting immediately.
2. Remove all protective wrapping prior to placing in toaster.
3. Avoid toasting the food with extremely runny ingredients such as butter.
4. Never attempt to remove bread jammed in the slots without unplugging the toaster from the
electrical outlet first, Be sure not to damage the internal mechanism or heating elements when
removing bread.
5. The bread slot is only applicable for toasting regular bread slice, like the irregular bread or round
bread; you can toast it on the toast rack.
1. Open the top cover of coffee maker; fill proper amount water into tank with carafe. The water
level should not exceed the MAX level in the gauge of coffee maker.
2. Place the funnel into the funnel support; make sure it is assembled correctly. Then put the filter
correctly.
3. Add coffee ground into filter. Usually cups of coffee need a level spoon of coffee ground, but you
may adjust according to you taste properly.
4. Insert the carafe on keeping warm plate horizontally.
5. Plug the power cord into the outlet, turning on the switch, the indicator will be illuminated. The
appliance will begin working. You may stop brewing by turning off the switch at any time, the
indicator will be extinguished. The appliance will continue brewing once switching on the switch again.
Note: You can take out carafe, pour and serve at any time. The appliance will stop dripping
automatically. But the time cannot exceed 30 seconds.
6. Do not open the tank cover when the coffee maker is operating.
7. You can take out carafe, pour and serve when finish brewing (about one minute later after the
coffee stops dripping out.)
Note: The coffee you get will less than the water you have inputted in, as some water is ab-
sorbed by coffee ground.
8. When the process is finished, if you do not want to serve immediately, do not unplug the power,
and keep the switch is on, the coffee can be kept warm in the keeping warm plate, For an
optimum coffee taste, serve it just after brewing.
9. Always turn the coffee maker off and unplug the power cord from the electrical outlet when the
coffee maker is not in use.
Note: pay attention to pour the coffee out, otherwise you may be hurt as the temperature of
coffee just finished is high.
Coffee maker Operation
12