Dust Collection Bag/Dust Extractor/Vacuum Cleaner; Attaching And Replacing The Sanding Arm - Westfalia 64 16 05 Original Bedienungsanleitung

Dust Collection Bag/Dust Extractor/Vacuum Cleaner

Please Notice! Grinding some material can lead to the formation of
hazardous or explosive dust. During operation a dust extractor or a
vacuum cleaner should be attached, or at least the included dust
collection bag (4) should be used.
1. For attaching the suction hose of a dust
extractor or vacuum cleaner, use the included
adaptor (6).
2. Attach the adaptor to the extraction flange of
the housing. The adaptor is equipped with
bayonet lock. Firmly push the adaptor with the
black rubber ring to the extraction flange and
turn clockwise to lock.
3. Connect the adaptor to the vacuum hose or the included durst
collection bag (4). To attach the dust collection bag, squeeze the
spring wire rings together and slide the spring wire rings over the
adaptor. To detach the dust collection bag, press the spring wire
rings together and remove the dust bag.

Attaching and Replacing the Sanding Arm

1. First, unplug from power mains. Slacken the tension of the
sanding belt by folding down the tensioning lever and remove
the sanding belt as described in the chapter "Installing/Replacing
the Sanding Belt".
2. Swing the tensioning lever back to extend the sanding arm all
the way. Loosen the regulating turn knob until the sanding arm is
free. Slide it out of the unit and insert the other sanding arm.
3. Tighten the sanding arm with the regulating turn knob until the
arm is straight in the unit. Make sure the spring is placed correct-
ly between the sanding arm and the sanding arm holder.
Operation
13