Cleaning The Cabinet; Maintenance - Sony UP-DF500 Bedienanleitung

Cleaning

Cleaning the Cabinet

Clean the cabinet, panel and controls with a soft dry
cloth, or a soft cloth lightly moistened with a mild
detergent solution. Do not use any type of solvent, such
as alcohol or benzine, which may damage the finish.
Note
Be sure to set the ON/STANDBY switch on the front
panel to STANDBY before cleaning the cabinet.

Maintenance

Perform the following maintenance regularly after every
500 printings.
• Replacing the cleaning roller
• Cleaning the thermal head and separation rubbers
• Cleaning the fan filter
In addition to the above maintenance, regular
maintenance is required after every 5,000 printings.
However, you should ask your nearest Sony dealer to
perform this maintenance.
You can check the total number of prints using the
TOTAL PRINTS item of the INFORMATION menu.
Note
Before starting the following maintenance, be sure to set
the ON/STANDBY switch on the front panel to
STANDBY, and then the main POWER switch on the
rear panel to OFF.
To replace the cleaning roller
The supplied cleaning kit contains the cleaning rollers
(for replacement) and wet pads.
Proceed as follows to replace the cleaning roller with a
new one.
1
Pull the lever toward you to open the front cover.
2
Hold the left side of the cleaning roller and remove
it by sliding it toward the right.
Cleaning roller
5
Cleaning