Operating The Alarm System - Westfalia DIY-12 Bedienungsanleitung

DIY-12.book Seite 35 Dienstag, 27. März 2007 3:47 15
DIY-12
9

Operating the alarm system

9.1 Arming the alarm system
➤ Switch the ignition off.
➤ Get out of the vehicle.
➤ Ensure that all doors and covers are closed.
➤ Press the ON/OFF button on the remote control.
✓ The alarm system sounds a confirmation tone if this function has not been
deactivated.
✓ The status LED starts flashing. First, only the ignition is monitored. After
five seconds, the alarm system is fully armed. The shock sensor and the
voltage sensor are also monitored.
Note
Only if the optional door contact or bonnet contact switches are
connected:
If the alarm system is armed while the door or bonnet are open,
two acknowledgement tones are emitted (if this function is not
disabled) to indicate the fault. Although the alarm system is armed,
the sensor area is excluded from monitoring until the fault is
eliminated, for example by closing the door.
Arming the alarm system in such a way that the vehicle can remain
occupied
You can set the alarm system so that the shock sensor does not trigger an
alarm, for example if you want to leave a pet in the vehicle.
➤ Press the ON/OFF button on the remote control.
✓ The alarm system sounds a confirmation tone if this function has not been
deactivated.
➤ Press the P button on the remote control within five seconds.
✓ The alarm system sounds a confirmation tone if this function has not been
deactivated. The ignition is monitored. After five seconds, the alarm
system is fully armed except for the shock sensor.
Operating the alarm system
35