Maintenance; Troubleshooting; Optional Accessories - Makita DX01 Gebrauchsanleitung

3. Remove the dust container from the attachment. (Fig. 6)
4. To open the dust container, raise the lever lightly and then pivot the transparent section. (Fig. 7)
5. Empty the dust container by tapping it lightly.
Be careful not to let out excessive dust into the air.
6. Remount the dust container in place on the attachment.

MAINTENANCE

WARNING:
• Always be sure that the tool is switched off and battery cartridge is removed before attempting to perform inspection
or maintenance.
NOTE:
• Do not use water, oil, grease, detergent or cleaning agents.
• Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result.
Cleaning of the attachment
Clean the attachment using only a dry rug and a dry brush.
Wear respiratory protection when cleaning.
Replacing the filter
Check the filter regularly for damage and if damaged, replace the old filter with a new one.
To replace the filter, follow the procedure below. (Fig. 8)
1. Press the dust container release button and with the button depressed pivot it on the lower side axis.
2. Remove the dust container from the attachment. (Fig. 9)
3. Pry up the filter cover on the dust container using a slotted bit screwdriver to be inserted into the slit. (Fig. 10)
4. Pull the old filter away from the dust container by hand. (Fig. 11)
5. Put a new filter in the original position. (Fig. 12)
6. Snap the filter cover on the dust container. (Fig. 13)
7. Remount the dust container in place on the attachment.
Replacing the sealing cap (Fig. 14)
Using a worn or damaged sealing cap may cause poor dust collection.
Check the sealing cap regularly. When the sealing cap is worn or damaged, replace it as follows.
1. Remove the sealing cap from the dust extraction system by hand.
2. Put a new sealing cap on the dust extraction system so that the protrusion on it is positioned on the upper side.
To maintain product SAFETY and RELIABILITY, any other maintenance or adjustment should be performed by Makita
Authorized Service Centers, always using Makita replacement parts.

TROUBLESHOOTING

Fault
Unusual dust emission

OPTIONAL ACCESSORIES

CAUTION:
• These accessories or attachments are recommended for use with your Makita dust extraction system specified in
this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use
accessory or attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
• Dust container (with filter)
• Filter
NOTE:
• Some items in the list may be included in the tool package as standard accessories. They may differ from country
to country.
Possible cause
The dust container is full.
The sealing cap is worn or
damaged.
Remedy
Emptying the dust container.
Replace the sealing cap.
7