Assembly; Start-Up - Westfalia 80 01 15 Bedienungsanleitung

Assembly

For transport protection the steam mop is
supplied partly assembled. Please assemble
the appliance as follows:
1. Connect the steam mop with the steam
foot (10). Make sure the parts fit into each
other.
2. Connect the 2 pieces of the tube (4) and
insert the assembled tube into the steam
mop.
3. Fill the water tank with normally temperate
tap water or preferably distilled water. Do
not add any chemicals. Do not fill the tank
with more than 400 ml water.
4. Place the water tank on the steam mop
and engage it with the locking lever (5).

Start-up

1. Place the floor cloth (13) on the ground
with the hook and loop fastener facing
upwards. Then press down the steam foot
on the cloth. The bottom side of the steam
foot is equipped with hook and loop
fasteners that match the fasteners on the
cloth.
Never use the steam mop without floor cloth!
2. Unwind the cord completely. Run the power cord over the cord storage hook
(2) and make sure the cord cannot become a tripping hazard. Do not pass
over the power cord with the steam foot.
3. Plug in the power cord to the power mains. The indicator lamp (9) lights up.
4. Use the steam control knob (7) to adjust the amount of steam. Within approx.
30 seconds the steam mop will be ready for use. Turn the steam control in
direction OPEN for full steam and in direction CLOSE in order to minimize the
amount of steam or to switch off completely.
Operating
16