Setting up the Height Adjustment Post / Crossbar
Assembly (Fig. 5 – 8)
1. Place height adjustment post (D) into open table
leg channel.
2. Place lock pin and chain assembly (G) into
desired hole to lock it in place.
3. Attach thermoplastic star knob (K) to lock pin and
chain assembly by placing the end ring on the
chain around the shank of the knob.
4. Screw the star knob into the post of the leg
assembly.
5. Repeat steps on the other side. Make sure to
match the height of the first side.
6. Tighten star knobs.
7. Install crossbar (F) using one M8 x 54 mm cross-
head screw (N4), large washer (L) and 8 mm lock
nut (M2). Repeat this step on the other side.
8. Tighten crosslink bar screws.
Assembly Instruction
14