Alarm Display - Sony LG10 Bedienungsanleitung

7. Alarm Display

Display
Flashes
24
When any one of the displays described below appears, reset and perform the operation from the
beginning.
Trouble
When the scale is not connected:
Scale disconnected Turn the power off, connect the scale, and turn the power back on again.
The display will be reset to "0".
When the scale movement exceeds the maximum response speed of the counter
Excess speed
unit. (This alarm also functions when the machine receives a great shock.)
Overflow
When the display overflows, "F" is indicated in the most significant digit.
When the power fails momentarily during measurement.
Power failure
Error in stored data When the stored data has been changed by noise, etc.
Note
When an error in the stored data is shown by "
according to "5-1. Initial Settings". If any erroneous setting is found, make a correct setting again.
Causes
" flashing on the display, check the settings