Installation; Connection Of Cables - Sony LG10 Bedienungsanleitung

3. Installation

3-1. Connection of Cables

Fasten the connecting cables to stationary members to prevent accidental disconnection. Be sure
to turn off the power of the counter unit before connecting or disconnecting the connector.
First axis scale
Second axis scale
Third axis scale
!
For safty sake, be sure to connect the supplied power cord in between ground terminal of unit and ground.
Connection precautions
These are precautions for connecting the scale to the counter unit.
Procedure of connecting the cable
Since a precision connector is used for this unit, please be careful connect to the counter unit in a
gentle way following the order described below.
1
Remove the two screws securing the joint cover on the back side of the counter unit and then
remove the cover.
2
Insert the adapter of the cable gently to the joint of the counter unit.
(There is approximately 1 mm / 0.039" clearance between the mounting plate and the backside of
the counter unit.)
Back-side panel
Adaptor
SIGNAL IN 1
SIGNAL IN 2
SIGNAL IN 3
R
Adaptor mounting plate
∼100V-230V
AC IN
35VA
!
Power supply
Ground terminal
1 (0.039")
5