Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Chamfering Edges
In the centre of the planing sole there is a
V-Groove (14) for chamfering edges.
To plane a chamfer, place the electric planer
on the edge of the workpiece with the
V-Groove. Now plane the chamfer in the
desired angle. For best result, move the
machine only very slowly.
Screws for Adjusting the Cutting Edge Height
The height of the blade shaft resp. the height of the planing blades in the blade
carrier can be adjusted with both adjusting screws (20). The height is already
adjusted by factory and should only be re-adjusted, in necessary, by a profes-
sional. The cutting edge height has to be adjusted in such a way that the planing
blades just do not touch the workpiece when the front sole is set in the lowest
position.
Replacing the Drive Belt
Before undertaking any work on the machine, pull the power plug.
1. Loosen the three screws and remove the belt cover (8).
2. First attach the new drive belt of
the same size and dimension on
the small wheel. Place the drive
belt over the large wheel by
simultaneously turning the large
wheel.
3. Re-attach the belt cover (8) on
the housing and tighten the
cover with the screws.
Make sure the belt does not have more than 5 mm of slack between the
motor shaft and the drive shaft.
Operation
17
Werbung
Inhaltsverzeichnis
