Parkside HG09502 Bedienungs- Und Sicherheitshinweise Seite 7

ø Thread Thread pitch ø Core hole
M3 0.5 mm
M4 0.7 mm
M5 0.8 mm
M6 1.0 mm
M7 1.0 mm
M8 1.25 mm
M10 1.5 mm
M12 1.75 mm
ø Thread Thread
per inch
1/8" 27
˜ Cutting external threads
(Figure B)
Note: Use cutting oil to reduce the friction
between the workpiece and the die 1 .
Determine the required thread.
Select the thread to match the bolt
diameter. This should be slightly smaller
than the nominal diameter of the thread
(see table below).
Slightly chamfer the leading edge of the
bolt. This will ease the work of cutting the
first threads.
2.5 mm
3.3 mm
4.2 mm
5.0 mm
6.0 mm
6.8 mm
ø Thread
8.5 mm
10.2 mm
ø Core hole
8.8 mm
ø Thread
Mount the selected die 1 in the die stock 2 .
Place the die 1 on the bolt to be cut.
Ensure that the arms of the die stock 2 are
at right angles to the bolt to be cut.
Turn the die stock 2 slowly clockwise
using even pressure.
If necessary turn it backwards slightly to
break up the accumulated metal shavings.
Thread pitch
M3 0.5 mm
M4 0.7 mm
M5 0.8 mm
M6 1.0 mm
M7 1.0 mm
M8 1.25 mm
M10 1.5 mm
M12 1.75 mm
Thread
per inch
1/8" 27
ø Bolt
2.9 mm
3.9 mm
4.9 mm
5.9 mm
6.9 mm
7.9 mm
9.8 mm
11.8 mm
ø Bolt
9.62 mm
GB 7