Westfalia LASER 2000 HW538T Bedienungsanleitung Seite 20

Problem
Weak Suction
Power
Motor does not
operate
Motor gets hot
All manuals and user guides at all-guides.com
Troubleshooting
Cause
Exhaust Filter dirty
Dust Container full
Main Filter and Pre-filter
dirty/blocked
Suction Hose blocked
Suction Control on the tele-
scope tube is open
Suction Control on the cleaner
is too low
Motor Filter dirty
Carpet/Floor Brush blocked
ON/OFF Switch is off
Plug is unplugged
Motor is defect
A hot motor is normal if the machine is running for an extended
period of time. If the machine gets too hot you should switch it
off for 15 minutes and allow cooling down.
Note: Take care that the suction openings and the exhaust
openings of the motor unit are not blocked or covered while
using the machine, to avoid overheating the motor.
Solution
Clean Exhaust Filter
Empty Dust Container
Clean Main Filter and Pre-filter
Tap out Suction Hose
Close the Suction Control on
the telescope tube
Increase the Suction Control
on the cleaner
Tap out Motor Filter
Clean Carpet/Floor Brush
Switch the cleaner on
Plug in
Have it repaired
15