Werbung
cable to the negative battery terminal. The charg-
ing condition indicator (7) shows the voltage of the
battery.
Attention:
verse polarity protection and the short circuit
protection are not active. Therefore, make
sure the polarity is correct and the electrical
protection is correct to avoid arching!
3. Press and hold the ON/OFF button (4) until the
control LED (6) lights up green.
4. When the control LED lights up green continuous-
ly, you have 30 seconds for a starting attempt.
5. Turn on the engine.
When the engine is running turn on a powerful
consumer, e.g. the heated rear window to com-
pensate the voltage peak caused by disconnect-
ing the box. Turn off the box with the button (4)
and first disconnect the black negative cable and
then the red positive cable. Turn off the consumer
and operate the vehicle long enough to build a
charge in the battery.
Glow Mode
In cold weather, the glow plugs in most diesel vehicles
will be preheated electrically. This is indicated by the
GLOW indicator on dashboard. The process needs a
current of 40 – 60 Amp and takes about 4 – 6 seconds.
1. In this case, after the jump starter is fully recharged
and connected, press the GLOW button (5).
2. Start the engine after preheating.
Operation
In the manual booster mode the re-
18
Werbung
